Electrical Properties Testing Canberra Businesses Rely On
The technical core of test and tag compliance — measuring whether equipment is actually safe to operate, not just whether it looks fine.
What Is Electrical Properties Testing?
Electrical properties testing is the process of measuring an item's electrical characteristics — including insulation resistance, earth continuity, and leakage current — to confirm it's safe to use under AS/NZS 3760. We provide this across Canberra as part of full test and tag compliance.
ACT PRO Services is a Canberra-based provider of data cabling and test and tag safety compliance services, supporting residential, commercial, corporate, and industrial clients across the ACT.
How we carry out electrical properties testing
Insulation resistance testing checks that an item's internal insulation is intact and not allowing current to leak where it shouldn't. Earth continuity testing confirms that any exposed metal parts are properly connected to earth, so a fault current has a safe path away from the user.
We also check leakage current on relevant equipment — even a small increase can indicate developing insulation failure before it becomes a visible or dangerous fault. Every test is performed using calibrated equipment and recorded against a clear pass or fail threshold.
The standards we test against
All electrical properties testing follows AS/NZS 3760, the Australian and New Zealand standard covering in-service safety inspection and testing of electrical equipment, setting out the specific tests required, acceptable pass thresholds, and recommended testing intervals based on equipment risk category.
Frequently asked questions
It involves measuring an item's insulation resistance, earth continuity, and leakage current using calibrated test equipment, recording specific readings rather than just a pass or fail result.
Insulation resistance testing checks that an item's internal insulation is intact and not allowing current to leak where it shouldn't — a key indicator of electrical safety and a low reading can indicate developing failure.
Costs depend on the number of items being tested and the type of equipment involved. We provide a free quote after understanding your equipment count and site.
It's one part of the full test and tag process — the technical measurement step that follows the visual audit. We provide both as part of a complete test and tag service.
Testing frequency depends on the equipment's risk category and operating environment under AS/NZS 3760, ranging from every 3 months for high-risk industrial equipment to annually for general office equipment.
Book an Appointment
Pick a date and time that works for you — we'll confirm by email within minutes.